cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1218
Views
0
Helpful
1
Replies

TCP Port issue

syedhaq007
Level 1
Level 1

Hi,

Need help!! Thanks in Advance!!

 

We have public IP subnets from which we configured few IPs on the devices with particular ports like 5865 and all other ports are block in router as well as firewall .. but when i do telnet to ports 80,21,143,110,25,5060,8008,2000 it is open.. this i got from nmap scan.

If i telnet with the IPs which are not in use, that also opens telnet session.. to dig more i have applied one deny ACL for port 80 then i see traffic and if i allow the port 80 then i see traffic on Fortigate too.. Im not sure what is happening.. hows these ports are opened when everything is blocked..

 

Regards

1 Reply 1

Jaderson Pessoa
VIP Alumni
VIP Alumni
Do you apply acl that block traffic in which interface? lan or wan ...
Which ip for test was used? public ip or internal ip?
Jaderson Pessoa
*** Rate All Helpful Responses ***
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: