Unable to change parts of device configuration in prime infrastructure 3.9

itsec123 · ‎04-13-2021

Hello everyone,

I successfully added some devices to my prime infrastructure 3.9 using SNMP and SSH credentials. Now the devices are all in state "managed". But I am unable to change the device configuration or at least parts of it. I can change des Interfaces, VLANs and ACLs but some other features are not showed in configuration tab. For example I want to turn on the scp server. I dont see any error messages. What am I doing wrong?

marce1000 · ‎04-13-2021

- Have a look at the compatibility information :

https://www.cisco.com/c/dam/en/us/td/docs/net_mgmt/prime/infrastructure/3-9/supported/devices/PI39-Supported-Device-List.xlsx

Meaning , you also need to look at the minimum IOS/XE software versions needed on the device for the particular prime version you are using.

M.

-- ' A nun once asked a penguin ' do you think the earth is flat ? ; the penguin replied :
Madam, it all depends , in Riemann geometries the earth can be perfectly flat! The nun thanked him , he tripped and fell forward : the poor animal had forgotten that he might be living in a Riemann geometry too!