10-31-2019 02:06 AM - edited 10-31-2019 02:28 AM
hello,
i'm unable to see any new logs about from Mar 8 in Cisco Nexus C9372PX
my logging configuration is as follows:
CORENEXUS02# show logging Logging console: enabled (Severity: critical) Logging monitor: enabled (Severity: notifications) Logging linecard: enabled (Severity: notifications) Logging timestamp: Seconds Logging source-interface : enabled (Interface: loopback11) Logging server: enabled {10.22.34.116} server severity: notifications server facility: local7 server VRF: lan server port: 5560 Logging logflash: enabled (Severity: notifications) Logging logfile: enabled CORENEXUS02# show running-config | include logging logging level snmpd 3 ntp logging logging server 10.22.34.116 5 port 5560 use-vrf lan logging source-interface loopback11
no logs are sent to syslog or shown is show logging.
What can i do ? Thank you.
Tried to add these lines:
logging level snmpd 6 logging level netstack 3 logging level icmpv6 3 logging level arp 3 logging level adjmgr 3
doesnt help..
Thank you
10-31-2019 05:31 AM
- You have a number of none-defaulted parameters (highlighted) in the following commands :
logging server 10.22.34.116 5 port 5560 use-vrf lan logging source-interface loopback11
- Why are these necessary and or why do you use them ?
M.
10-31-2019 06:17 AM
thanks for reply. i'm using syslog to send all logged messages to syslog server.
But i noticed that there're no logs from this device in syslog, then i started to check logging in the local box, and ceased to see any log messages in it. So asking for help here..
10-31-2019 08:50 AM
>So asking for help here..
Then you also need to respond to the specific questions that I asked you.
M.
11-11-2019 11:52 PM
ok, i will try to answer them again:
logging server 10.22.34.116 5 port 5560 use-vrf lan logging source-interface loopback11
first line means that logs should be sent to syslog server also.
and second one, that the source ip address of packets sent to that syslog should be used as of loopback11.
I will repeat myself, but i strongly dont see that these commands would cause the problem i'm experiencing.
So, any help ?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide