cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1136
Views
0
Helpful
0
Replies
Highlighted
Beginner

WAP150 doesn´t joyn Single Point Setup Network of two WAP371

Hi,

we want to extend our WLAN setup of two WAP371 with a WAP 150. All three Access points are connected to the same Cisco SG350-10P. The existing WLAN is configured via single point setup. Now when we try to add the new WAP150 via single point setup it doesn´t join the other two. I´ve tried to configure the cluster management address on the WAP150 but the result was that no longer the WAP371 master answers on that address but the WAP150.

Firmware on the devises:

SG350: 2.5.0.92

WAP371: 1.3.0.7

WAP150: 1.1.09, 1.1.2.4.

First tests were with WAP150 on 1.1.2.4, performed factory reset on WAP150 after firmware downgrade.

Any ideas are welcome.

 

Best regards,

Mike

0 REPLIES 0
Content for Community-Ad