4110 Fail-open module FPR4K-NM-6X10SR

[sindandoh]

Hello, just ordered the FPR4K-NM-6X10SR fail-open module for 4110. Interested to know whether SFPs are required to be used in conjunction with this module, or the built-in (blue plastic) connectors are where the fiber should be plugged in. 

Thanks,  

[inderdeeps]

@sindandoh : This is a Network Module and you need additional SFP+ for the same. 

https://www.cisco.com/c/en/us/td/docs/security/firepower/4100/hw/guide/b_install_guide_4100/overview.html 

[balaji.bandi · Accepted solution]

Not installed myself, But Look at the Module you do not need any SFP i guess here - the patch lead go directly to the modules. as suggested installation you need to right Code running to recognise this module.

[Marvin Rhoads]

No SFP is required.

Note that FTW (Fail to Wire) netmods are only used with the Firepower running in pure IDP/IPS mode - i.e., not with routed firewall interfaces.