- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-25-2013 11:03 AM - edited 03-11-2019 07:56 PM
Hello,
I have a 5520 ASA running ASA Version 8.4(4)1, ASDM 6.4(9) that has remote access VPN enabled and hands off to a Windows 2008 R2 box handing out DHCP addresses. We attempted to make an IP address reservation based upon MAC address for a single end user. It looks like the ASA is not passing the unique identifier from the remote user down to the Windows server.
I have read a lot of forum posts where people are asking about reserving IPs for raVPN based on MAC addresses and it is only available using version 9 and IP V6.
Is this the case even if the ASA is not handing out the DHCP IPs?
Thanks
Solved! Go to Solution.
- Labels:
-
NGFW Firewalls
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-25-2013 04:31 PM
As long as I know (an example of that is this discussion: https://supportforums.cisco.com/thread/2129315 ) it's not supported.
But you can do it based on username on the ASA side ofcourse
username
vpn-framed-ip-address
Rate all of the helpful posts!!!
Regards,
Jcarvaja
Follow me on http://laguiadelnetworking.com
Senior Network Security and Core Specialist
CCIE #42930, 2xCCNP, JNCIP-SEC
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-25-2013 04:31 PM
As long as I know (an example of that is this discussion: https://supportforums.cisco.com/thread/2129315 ) it's not supported.
But you can do it based on username on the ASA side ofcourse
username
vpn-framed-ip-address
Rate all of the helpful posts!!!
Regards,
Jcarvaja
Follow me on http://laguiadelnetworking.com
Senior Network Security and Core Specialist
CCIE #42930, 2xCCNP, JNCIP-SEC
