Hi Dears,
how to change the int BVI1 to int g1/2 on sfr.
I have factory rest the ASA without factory rest the sfr, after config the ASA and removed the bridge group 1 and interface BVI1, and the int g1/2 is the inside interface. that is not ping-able ASA with sfr. And the ASDM not display the firepower.
show summary on sfr
----------------------[ BVI1 ]----------------------
Physical Interface : BVI1
Type : ASA
Security Zone : None
Status : Enabled
Load Balancing Mode : N/A
--------------------[ outside ]---------------------
Physical Interface : GigabitEthernet1/1
Type : ASA
Security Zone : None
Status : Enabled
Load Balancing Mode : N/A
---------------[ GigabitEthernet1/2 ]---------------
Physical Interface : GigabitEthernet1/2
Type : ASA
Security Zone : None
Status : Enabled
Load Balancing Mode : N/A
--------------------[ inside_2 ]--------------------
Physical Interface : GigabitEthernet1/3
Type : ASA
Security Zone : None
Status : Enabled
Load Balancing Mode : N/A
--------------------[ inside_3 ]--------------------
Physical Interface : GigabitEthernet1/4
Type : ASA
Security Zone : None
Status : Enabled
Load Balancing Mode : N/A
--------------------[ inside_4 ]--------------------
Physical Interface : GigabitEthernet1/5
Type : ASA
Security Zone : None
Status : Enabled
Load Balancing Mode : N/A
--------------------[ inside_5 ]--------------------
Physical Interface : GigabitEthernet1/6
Type : ASA
Security Zone : None
Status : Enabled
Load Balancing Mode : N/A
--------------------[ inside_6 ]--------------------
Physical Interface : GigabitEthernet1/7
Type : ASA
Security Zone : None
Status : Enabled
Load Balancing Mode : N/A
--------------------[ inside_7 ]--------------------
Physical Interface : GigabitEthernet1/8
Type : ASA
Security Zone : None
Status : Enabled
Load Balancing Mode : N/A
---------------------[ c plane ]---------------------
IPv4 Address : 127.0.2.1
----------------------[ eth0 ]----------------------
Physical Interface : eth0
Type : Management
Status : Enabled
M D I/M D IX : Auto
M T U : 1500
MAC Address : 4C:77:6D:E F:6C:94
IPv4 Address : 192.168.2.5
----------------------[ tun1 ]----------------------
---------------------[ tunl0 ]----------------------
----------------------------------------------------
