01-19-2017 07:45 AM - edited 03-12-2019 01:48 AM
Hello,
I recently purchased an ASA 5506x box, but I had problems connecting to the ASDM after running through the Startup Wizard. I found out that the cause was to do with Windows 10 and the solution was to upgrade the FirePower module.
I went ahead and was able to install the Cisco_Network_Sensor_6.0.0_Pre-install-5.4.1.999 fine, but when installing the Cisco_Network_Sensor_6.0.0-1005, it stalled and I'm not too sure why.
If I open the ASDM now I can only see the ASA FirePower Status tab, but not the other Firepower tabs.
I have the log of the upgrade process attached.
Thanks
Solved! Go to Solution.
01-19-2017 09:18 AM
You have not started to configure FirePower, right? Then I would skip all troubleshooting attempts and directly install FirePower-version 6.1. That is probably less work than to run all the update/upgrade-steps.
01-19-2017 09:18 AM
You have not started to configure FirePower, right? Then I would skip all troubleshooting attempts and directly install FirePower-version 6.1. That is probably less work than to run all the update/upgrade-steps.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide