ASA 5506x sfr module failed upgrade from 5.4.1 to 6.0.0

[lee]

Hello,

I recently purchased an ASA 5506x box, but I had problems connecting to the ASDM after running through the Startup Wizard. I found out that the cause was to do with Windows 10 and the solution was to upgrade the FirePower module. 

I went ahead and was able to install the Cisco_Network_Sensor_6.0.0_Pre-install-5.4.1.999 fine, but when installing the Cisco_Network_Sensor_6.0.0-1005, it stalled and I'm not too sure why.

If I open the ASDM now I can only see the ASA FirePower Status tab, but not the other Firepower tabs.

I have the log of the upgrade process attached.

Thanks

[Karsten Iwen · Accepted solution]

You have not started to configure FirePower, right? Then I would skip all troubleshooting attempts and directly install FirePower-version 6.1. That is probably less work than to run all the update/upgrade-steps.