Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Daear All,I have two ASA device configured with Active/Standby failover configuration.Now the Standby unit is active and Primary unit is in standby ready state.If I enter write standby command in standby unit which is currently active will it rewrite...
Dear All,Question1. Is it possible to establish site to site VPN tunnel between Site A and Site B note: There is a dedicated link, it is in same subnet 192.168.10.0/30 Valid hosts 192.168.10.1 and 192.168.10.2 (assigned to firewall)VPN tunnel configu...
Dear All,VLAN's are not populating in CAT3560 which is cascaded with nexus 2k switch.NEX# show interface Ethernet101/1/2 switchportName: Ethernet101/1/2 Switchport: Enabled Switchport Monitor: Not enabled Operational Mode: trunk Access Mode VLAN:...
Dear All,I would like to know whether this command is supported by CAT2960 switches "switchport trunk encapsulation dot1q". I tried it is not working. Do we have any alternate for this?RegardsBR
Hi David,Do you have SIP service policy/Global timeout enabled on your firewall. Can you share the diagram shows the conection detailsRegardsBalajirajah P B
Thanks. I'm getting following error.ASA# write standbyBuilding configuration...Configuration can only be replicated from the Active unit.[FAILED] This host: Primary - Active Active time: 35246599 (sec) slot 0: ASA...
