ā11-17-2010 04:55 PM - edited ā03-11-2019 12:11 PM
I have two ASAs, 5505 and 5510, both running v.8.2(3). When I try to SSH in, using Putty, it just will not connect. However, if I reload the ASA, I will be able to connect. This is the only line from the syslog:
6 Nov 18 2010 00:24:46 24.xx.xx.xx 51179 65.xx.xx.xx 22 Built inbound TCP connection 206652 for outside:24.xx.xx.xx /51179 (24.245.58.61/51179) to identity:65.xx.xx.xx /22 (65.xx.xx.xx /22)
That is it.
However, if I do a remote access L2TP in, then I can access the inside interface/address through SSH fine. It is just the outside that times out. While I would figure it would be a configuration/ACL issue, it does work AFTER I do a system reload. It is only after a few days that I reboot does this timeout issue occur.
Is this common? Known? Happening to anyone else? Any fix, solution, ideas, or tips would be greatly appreciated.
ā11-17-2010 07:21 PM
Looks like you might have been affected by either of the following bugs:
The issue is fixed in version 8.2.3(6).
ā11-18-2010 08:21 AM
Jennifer, thanks for replying.
Where and how do I find 8.2.3(6)? In the download section all I see available is the 8.2.(3) dated August 2010. Do I need to make a special request? There does not seem to be any link anywhere to download this version, or maybe I am just completely overlooking something.
ā11-18-2010 08:39 AM
Hi Sean,
The interim releases are not available on CCO.
Please open an SR with TAC and they should be able to publish you the image for download.
Cheers,
Nash
ā11-18-2010 03:56 PM
Yes, please open a TAC case as Avinash' advise. The TAC engineer can publish you the interim release upon your request.
Please kindly mark this post as answered if you have no further question. Thanks.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide