how can apply route-map rules to an interface ?
i set up some rules but i cannot apply these rules any interface.
Thanks a lot.
Are you looking for this?
hostname(config-route-map)# match interface if_name
Note: Please mark answers if they are helpful.
Thank you Kanwal.
in a cisco router you can apply your route-map by using command ip policy map ... İ didnt find any command like this. İ set up some match and set conditions but i do not apply any interface.
can i use route-map to manipulate routing table İn asa 5585-x.?
You use the "ip policy route-map ..." command when it is PBR but the ASA does not support PBR.
You can apply your route map under your routing protocol configuration when you redistribute from one routing protocol to another.
What is it you are trying to do ?
Thank you for all replies.
Unfortunately, i have to change next hop for specific source address. I guess this is not possible.
A new feature added on ASA with 9.4 image. We can apply a route-map in physical interface by command
policy-route route-map NAME.
Thanks for all reply.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: