cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
771
Views
5
Helpful
2
Replies

ASA 8.4(3) Syslogging Firewall logs

phillip0707_2
Level 1
Level 1

Hello,

I've got a few syslog servers I need to send specific informational that consists of the following:

Source/Destination/Service (Firewall Logs)

I'm having some difficulty located the proper syslog messages found in this link: http://www.cisco.com/en/US/docs/security/asa/asa84/system/message/logmsgs.html

Which syslog messages should I configure to enable this requirement?

Any help would be greatly appreciated.

Regards,

Phillip

1 Accepted Solution

Accepted Solutions

varrao
Level 10
Level 10

You would need to enable the logs at informational level or higher for it, you can refer to this doc for it:

https://supportforums.cisco.com/docs/DOC-18813

Also these logs shoudl be the one  that you should be interested in 302013 and 302014:

http://www.cisco.com/en/US/docs/security/asa/asa84/system/message/logmsgs.html#wp6482625

Hope that helps,

Thanks,

Varun

Thanks,
Varun Rao

View solution in original post

2 Replies 2

varrao
Level 10
Level 10

You would need to enable the logs at informational level or higher for it, you can refer to this doc for it:

https://supportforums.cisco.com/docs/DOC-18813

Also these logs shoudl be the one  that you should be interested in 302013 and 302014:

http://www.cisco.com/en/US/docs/security/asa/asa84/system/message/logmsgs.html#wp6482625

Hope that helps,

Thanks,

Varun

Thanks,
Varun Rao

Thanks for the quick answer Varun!  Much appreciated.

Regards,

Phillip

Review Cisco Networking products for a $25 gift card