03-17-2009 03:12 PM - edited 03-11-2019 08:06 AM
folks
can an asa have two separate external interfaces, each using a different NAT, both connected to the same isp router
i need to route traffic from my internal network through the asa and filter it based on destination address - all for http traffic
sounds a bit like policy based routing where i could use a route map and acls to match the destination
i'd appreciate any advice
thanks
03-17-2009 11:27 PM
..
03-27-2009 10:40 AM
you can use policy based nat to set the outgoing IP based on destination ip....
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide