Solved: ASA config standardization commands

raza555 · ‎03-07-2014

Hi,

In order to standardized/secure the ASA configurations, I am going to deploy the attached commands to several ASA from version 8.0 to 8.4. Although I have tested them and they work ok, but as precaution please advice that these commands will not delete ssh/ telnet/ http from ACL/NAT etc.

Also please advise that these commands will also work in PIX 6.3.

You response will give confidence before deployment and also help many others.

Thanks

Marius Gunnerud · ‎03-08-2014

The clear configure http and clear configure ssh will not remove any of the NAT or ACL statements.

I have not worked much on PIX, but I believe that the commands will also work with it. The only exception is the enabling of logging which I believe is done using logging on command.

Other than that it is very common for these commands to be configured on all ASAs.

--

Please remember to rate and select a correct answer

--
Please remember to select a correct answer and rate helpful posts

View solution in original post

Marius Gunnerud · ‎03-08-2014

The clear configure http and clear configure ssh will not remove any of the NAT or ACL statements.

I have not worked much on PIX, but I believe that the commands will also work with it. The only exception is the enabling of logging which I believe is done using logging on command.

Other than that it is very common for these commands to be configured on all ASAs.

--

Please remember to rate and select a correct answer

--
Please remember to select a correct answer and rate helpful posts