cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
785
Views
0
Helpful
1
Replies

ASA config standardization commands

raza555
Participant
Participant

Hi,

In order to standardized/secure the ASA configurations, I am going to deploy the attached commands to several ASA from version 8.0 to 8.4. Although I have tested them and they work ok, but as precaution please advice that these commands will not delete ssh/ telnet/ http from ACL/NAT etc.

Also please advise that these commands will also work in PIX 6.3.

You response will give confidence before deployment and also help many others.

Thanks

1 Accepted Solution

Accepted Solutions

Marius Gunnerud
VIP Advisor VIP Advisor
VIP Advisor

The clear configure http and clear configure ssh will not remove any of the NAT or ACL statements.

I have not worked much on PIX, but I believe that the commands will also work with it.  The only exception is the enabling of logging which I believe is done using logging on command.

Other than that it is very common for these commands to be configured on all ASAs.

 

--

Please remember to rate and select a correct answer

--
Please remember to select a correct answer and rate helpful posts

View solution in original post

1 Reply 1

Marius Gunnerud
VIP Advisor VIP Advisor
VIP Advisor

The clear configure http and clear configure ssh will not remove any of the NAT or ACL statements.

I have not worked much on PIX, but I believe that the commands will also work with it.  The only exception is the enabling of logging which I believe is done using logging on command.

Other than that it is very common for these commands to be configured on all ASAs.

 

--

Please remember to rate and select a correct answer

--
Please remember to select a correct answer and rate helpful posts
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers