Solved: ASA FIREPOWER ASDM ONLY STATUS TAB APPEAR

Kevin100 · ‎10-18-2016

HAI

I am deploying Cisco ASA 5545 with firepower services ,The issue is i can see only ASA firepower status tab only.

I can ping all interfaces including management

asa ver 9.62

asdm 7.6

Firepower 5.3.1-152

Firewall in active standby

I am not able to install licence through asdm.

Firecentre shows licese not install

ASA firepower status all up on asdm.

thank you

Marvin Rhoads · ‎10-20-2016

The ASA 5545-X requires FirePOWER services module software release 6.0 or later in order to manage it via ASDM.

Prior to that, you can only manage the module (and apply licenses and policies) via FireSIGHT Management Center (formerly Defense Center and now known as FirePOWER Management Center).

Once you have 6.0, you can choose one or the other management method - but never both at the same time.

View solution in original post

Marvin Rhoads · ‎10-20-2016

The ASA 5545-X requires FirePOWER services module software release 6.0 or later in order to manage it via ASDM.

Prior to that, you can only manage the module (and apply licenses and policies) via FireSIGHT Management Center (formerly Defense Center and now known as FirePOWER Management Center).

Once you have 6.0, you can choose one or the other management method - but never both at the same time.