Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HaiOne of our client has cisco 9800 wlc with 17.9 code and dna essentilas licence.Client requested to rate limit internet traffic by two mbps per user. Old 5504 controller it was easy in SSID but this option missing with 9800.please help
Hai new Cisco 9115AX AP came with controller mode and I needed to join a controller, no DHCP available on the network, how to enter static IP on AP, i tried to enter like old 1800 AP but the ping and connectivity not working.converted AP using wirele...
Hai, I am implementing a Wi-Fi project with mixed 1800 and 9100 AP with 9800 controllers.Will this create issues as some are Wi-Fi 6 capable and some are not?
Hi, I am planning to migrate some 1832i AP 8.5.171 to 9800 17.12.2, can we point the AP to the new WLC, will it upgrade itself? Is any code conversion required prior?Both are in HA and ISE with Mac authentication for clients, what's the preferred wa...
I have an existing setup with 1800 Mobility Express, i want to add a new ap 2702i, i use the same code as per the compatibility matrix but, the AP does not join, DTLS error, image mismatch again this time it shows 0.0.0.0
Please find attached logs
...
I tried this still it does not show up and the same message appears waiting for the preferred uplink IP configuration.Not show any ipAPA400.4E3C.5714>show ip interface brief Interface IP-Address Method Status Protocol Speed Duplex wired0 unassigned u...
Dear MarceThanks for the reply, I need to know if this causes issues in roaming as some are wifi 6 and some are not. If causes issues configurations suggestions for better deployment
Hai RichI started the migration ,9800 LF controller, upgraded the firmware to 17.12.2, 2504 controller to 8.5.182.11But i am getting dtls error, on console of 1832i AP i see message no suitable ap manager found ,i changed dtls to version all in cli.S...
Hai so if the primary controller Ip is pointed will it upgrade directly to the latest image on 9800 as the old ap image is aos. 8.5,i read before need to convert t o an intermediate version then to the latest
