cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

2339
Views
0
Helpful
1
Replies
Daniel Stefani
Beginner

ASA FirePOWER - Inline Tap Mode

Hello,

I would like to understand the configuration of Inline Tap Mode in ASA with FirePOWER.

To operate in this mode, I need to configure the ASA policy-map to monitor-only or can keep inline and create an Intrusion-Policy on FMC with Drop When Inline option disabled?

What would be the right option?

Regards,

Daniel Stefani

1 ACCEPTED SOLUTION

Accepted Solutions
keglass
Rising star

Daniel,

I found that you posted this to the Cisco Support Community and a response was added. I am including the link here for others with the same question.

https://supportforums.cisco.com/discussion/12935776/asa-firepower-inline-tap-mode

Thank you for participating in the community. Please post again if you have additional questions.

Kelli Glass

Moderator for Cisco Customer Communities

View solution in original post

1 REPLY 1
keglass
Rising star

Daniel,

I found that you posted this to the Cisco Support Community and a response was added. I am including the link here for others with the same question.

https://supportforums.cisco.com/discussion/12935776/asa-firepower-inline-tap-mode

Thank you for participating in the community. Please post again if you have additional questions.

Kelli Glass

Moderator for Cisco Customer Communities

View solution in original post