cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3235
Views
0
Helpful
1
Replies

ASA FirePOWER - Inline Tap Mode

Daniel Stefani
Level 1
Level 1

Hello,

I would like to understand the configuration of Inline Tap Mode in ASA with FirePOWER.

To operate in this mode, I need to configure the ASA policy-map to monitor-only or can keep inline and create an Intrusion-Policy on FMC with Drop When Inline option disabled?

What would be the right option?

Regards,

Daniel Stefani

1 Accepted Solution

Accepted Solutions

keglass
Level 7
Level 7

Daniel,

I found that you posted this to the Cisco Support Community and a response was added. I am including the link here for others with the same question.

https://supportforums.cisco.com/discussion/12935776/asa-firepower-inline-tap-mode

Thank you for participating in the community. Please post again if you have additional questions.

Kelli Glass

Moderator for Cisco Customer Communities

View solution in original post

1 Reply 1

keglass
Level 7
Level 7

Daniel,

I found that you posted this to the Cisco Support Community and a response was added. I am including the link here for others with the same question.

https://supportforums.cisco.com/discussion/12935776/asa-firepower-inline-tap-mode

Thank you for participating in the community. Please post again if you have additional questions.

Kelli Glass

Moderator for Cisco Customer Communities

Review Cisco Networking for a $25 gift card