cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1502
Views
0
Helpful
4
Replies

ASA routing redirect

RexPr
Level 1
Level 1

I have the network configuration as in the picture.

Senza nome 1.gif
When I make traffic from 192.168.2.50 toward 192.168.1.x.
the data are sent to default gw (as due): the ASA, but the ASA doesn't redirect to 192.168.2.2, the gateway for the 192.168.1.0 network.
The ASA's documentation says that this is behavior is by design. Ok. But how to make traffic to 192.168.1.0 maintaining 192.168.2.1 as default gw for network 192.168.2.0.

This is not clear to me.

Thanks for help,
Fabrizio

Fabrizio www.rfc.it
4 Replies 4

RexPr
Level 1
Level 1
Of course, I have a static route to 192.168.1.0
S 192.168.1.0 255.255.255.0 [1/0] via 192.168.2.2, inside
Fabrizio www.rfc.it

balaji.bandi
Hall of Fame
Hall of Fame

What is the device you connecting all these device ? .50 .2 .1 in to Switch ?

 

what is the GW for .2 ? if possible post the configuration of router and ASA

 

 

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

>>> What is the device you connecting all these device ? .50 .2 .1 in to Switch ?
The ASA (ASA 5506-X) ports.

 

>>> what is the GW for .2 ? if possible post the configuration of router and ASA
The ASA (ASA 5506-X)

 

 

 

Fabrizio www.rfc.it

jroy777
Level 1
Level 1

Like I always said, ASA is POS. Cisco should have stuck to routers and built the security into the routers. Every other device on the planet gives you the ability to redirect route traffic. Just stupid thinking from their Security designers

Review Cisco Networking for a $25 gift card