06-05-2015 08:12 AM - edited 03-11-2019 11:03 PM
I just upgraded from 8.3 to 9.4 and reset to factory on this 5505. Now when I try to set the security level on any interface I received this error:
[ERROR] Interface
No interface specified for interface_command
Interface
[ERROR] security-level 100
security-level 100
^
ERROR: % Invalid input detected at '^' marker.
Of course I have no issues setting fro CLI. I tried downgrading ASDM with no change in behavior.
Any ideas?
06-05-2015 08:19 AM
Hi,
Can you enable the preview configuration option from the preferences on the ASDM and check what commands are being sent to the ASA device and post it on this post.
Also , explain the changes that you are making on the ASDM.
Thanks and Regards,
Vibhor Amrodia
06-05-2015 08:25 AM
I reset the asa to factory settings. I've added an interface named "other" which was automatically assigned vlan12. I can't set the security level on that interface. On creation, it successfully creates the interface, but assigns it security level of 0. If I try to assign it any other security level, I get the error posted above.
Enabling preview seems to explain why. This is what is being sent to the asa when attempting to change the level to 90:
Interface
security-level 90
To add to this, I can't change the security level of either inside or outside interfaces either - I get the same exact message.
06-05-2015 08:50 AM
Adding an interface with preview enabled results in the below being sent to the asa:
interface Ethernet0/3
switchport access vlan 22
Interface vlan22
no shutdown
nameif test
Interface
security-level 100
06-06-2015 05:04 AM
Hi,
I am sorry. I am able to understand that somehow the "interface" command is being sent which is error out.
I would request you to post some Screenshot of the changes you are trying to make and the initial config that u are starting with so that i can try to recreate this if possible.
Thanks and Regards,
Vibhor Amrodia
06-08-2015 05:46 AM
To recreate:
Update ASA 8.3 to 9.2(3)4
Install ASDM 7.4
Reset to factory defaults via ASDM
Using ASDM: add an interface and set any security-level
This is when you should see the error.
06-17-2015 11:31 AM
Were you able to reproduce?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide