Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Greetings,    I have a few ASA-5545-X's running 9.9.1(3) and we are about to add somewhere in the realm of 600+ anyconnect active connections. So, I'm thinking about DHCP pool sizing which I just want to build a /22 network. Can the community share t...

Hi,   I am currently studying Policy Based Routing on our CISCO ASA 5525. I have read that you need a license to do such command on the ASA which I checked and found that it has a License with the "show activation-key". When I tried to apply my route...

KyleHB by • Frequent Visitor
  • 1179 Views
  • 3 replies
  • 0 Helpful votes

I’ve created a bridge group interface named inside and I've assigned it an IP (192.168.1.1).Then I've created two interface inside_3 and inside_4, both assigned to the bridge group inside. Now if I make a nat rule, for example nat (inside,outside) st...

RexPr by • Level 2
  • 1011 Views
  • 1 replies
  • 0 Helpful votes

I was not even sure how to title this thread. Here is what's going on.   I have a 5506-X ASA with 3 isolated inside networks.   1: 10.10.1.0/24 on gi 1/2, let's call this LAN A 2: 10.10.2.0/24 on gi 1/3, let's call this LAN B 3: 10.10.3.0/24 on gi 1/...

softgrapes by • Community Member
  • 482 Views
  • 1 replies
  • 0 Helpful votes

Hi There,   I have an urgent problem, on which i cannot figure out how to deal with it.   I have an asa5506-X with two internal VLAN's (VLAN 10, VLAN 20 Guest Network) I Have one normal WAN Connection to the internet. I also have an special 2nd intra...

Dears, I have kept network analysis policies in a passive mode ( default mode) but the access control policies has default action of IPS that means if the traffic doesn't match it will pass by the IPS,   I have not enabled a network analysis policies...

adamgibs7 by • Level 7
  • 1916 Views
  • 5 replies
  • 0 Helpful votes

Hi All,   Could you please hemp me to select appropriate  device  image code  as we are planning to upgrade 9.3 to 9.6. Will it be possible to jump directly to 9.6 release . Please find the below screen short. Cisco Adaptive Security Appliance Softwa...

arindamsinha by • Frequent Visitor
  • 1515 Views
  • 2 replies
  • 0 Helpful votes

Hello,   Well I have this firewall Cisco ASA5516-X firepower with this default configuration:   timeout conn 1:00:00 half-closed 0:10:00 udp 0:02:00 sctp 0:02:00 icmp 0:00:02timeout sunrpc 0:10:00 h323 0:05:00 h225 1:00:00 mgcp 0:05:00 mgcp-pat 0:05:...

jona_board by • Frequent Visitor
  • 1551 Views
  • 6 replies
  • 0 Helpful votes

I have been getting conflicting information on Cisco ASAV on AWS. We had subscribed to Cisco ASAV pay by the hour on AWS . When we hit an issue and tried to raise a ticket with Cisco, Cisco would not support it as there was no license contract associ...

Review Cisco Networking for a $25 gift card