Network Security

i am facing a complicatedly situation, hoping can have your help. our new HQ office will have 2 internet broadband and setup on ASA5516X so the ASA has 2 outside ports and 1 inside port.   On outside-1 is a static IP broadband (has 16 IP addresses ) ...

Hello, I have 2 questions regarding the licensing of an ASA5585-SSP-10 HA cluster. #1 After activating a Security Context Upgrade key, is a reload required on the unit on which it is applied? #2 The standby unit is licensed for 2 security contexts. W...

Hi team I want change a Soho-Home Router from FTTH line for a classic ASA5506 but I have a problem, I support several ipsec tunnels to a third party firewall and crossing the soho router. This router is configured by redirect internet traffic to a dm...

Hello.  Does anyone have any scoping or sizing metrics around when to recommend adding the malware storage pack in the second ssd slot on the 2100s?

Hi All, I have a below doubt on my setup. I am not sure whether setup i have built is as per IDS standards or not but SNORT IDS is not capturing traffic. I want to be sure from switch end i have mapped the needs of IDS. Below is the setup i have buil...

Can I configure block or approve the url traffic in this way in a FMC? For example: *.gob *.edu *.gob.co Regards

Just trying to run a packet tracer on my Firepower device, and I do get output when I use the "diagnostic" interface.  However, if I try to use any of the actual interfaces, I get the following error: "An error occured while executing the Packet Trac...

Hello  I'm looking to order firewall with IPS/IDS support to integrate main site( 70 users ) with 10 branches (15 users/ site), any recommend model, i think  the ASA 5500-x is EoS and cisco advice to migrate to firepower appliance. thanks for help

Hello, What is the Management Interface on an ASA 5510 / 5520 meant to be used for...? I am not a firewall boffin by any means but recently I've had to set up both 5510 and 5520 ASA's, part of the set up was to use the management interface for the sy...

I can't connect via ASDM 7.5(2) 153 to newly installed ASA 9.4(2)11.   I can connect via https://host_ip/admin/exec/ sh ver or do any other command.   I also get unable to connect to via ASDM with Java Web Start to run too?  Running Java 8r111.    I ...

Has anyone had any luck in getting this working? I downloaded and installed on Win 7 64bit and after launching found myself not able to configure the agent due to not being able to navigate within the front end . I tried maximizing the window etc but...

Hi, I have to migrate ASA5510 to ASA5545x. This is a management firewall and takes care of hell lot of management traffic. So my concern here is when I shut down the old ASA5510 and bring in the new ASA5545x, the MAC addresses are going to be changed...