Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Hello, I just got started with the FMC1000 and I would like to use the 2nd NIC as a backup between our two distribution switches.  Linux has supported bonding from version 2.0 and I doubt that Cisco would have build the FMC on something that old. Can...

yaplej by Level 1
  • 632 Views
  • 1 replies
  • 0 Helpful votes

Hi there,recently i bought and installed new SSL certificates for the ASA, but the old invalid certificate still on the firewalli am thinking to delete it but im afraid its gonna cause some problemsanyone have some advise whether i should remove or c...

We have a version 5.4.x Firesight VM managing two 5525-X Firepower services and we are trying to upgrade to FMC6.2. Plan is to: 1. Build a brand new FMC 6.2 VM 2. Manually migrate policies to new FMC 3. Schedule down time to upgrade the firepower mod...

SIMMN by Spotlight
  • 769 Views
  • 2 replies
  • 0 Helpful votes

Hello "Download updates failed: Error parsing the update file. The file may have been corrupted or the download was incomplete." support.Sourcefire.com is it down tooday ? Best regard

by Not applicable
  • 2957 Views
  • 5 replies
  • 0 Helpful votes

Dear All memebers,Hope all be fine,I have a problem in Cisco ASA 5510 Firewall, when I get this firewall it was old ASA image and ASDM version, So I upload a new image and asdm and booting it, after reboot the firewall can't load it's image from flas...

Tawakkoli by Level 1
  • 2316 Views
  • 5 replies
  • 0 Helpful votes

Hi All When I adding ACE entry in the ACL via ACL Manager, I will got "Address cannot contain x.x.x.x/xx" error message. Does anyone meet this problem before? however, it can add via CLI. Thank you

Lin-Terry by Level 1
  • 1360 Views
  • 2 replies
  • 0 Helpful votes

Hello, We have 2 ASA 5520 firewalls working in active passive, below is the config for the outside interface. I can't show the real IP's so have changed them to these: 1.2.3.66 - Primary public IP 1.2.3.67 - Standby public IP ASA 5520 interface G...

Hello,  i am setting a new 860VAE-k9 ISR for a residential camp. is the firewall enabled in it by default or should i configure any rules in order to inspect the packets(basic protection needed)? all the traffic is basically due to browsing, streami...

When configuring a BOM in CCW and reading the NGFW datasheet, I am confused why 21xx and 41xx have three different appliances: NGFW, NGIPS and AMP. What I see is they all have the same software image and same price. what are the differences? do they ...

I have configured the management interface on an ASA 5525 as follows: interface Management0/0 description MGMT link to GOLABC012SW - F1/0/17 - VLAN 701 management-only nameif management security-level 100 ip address 143.16.191.45 255.255.255.0 The ...

tomyip by Level 1
  • 3032 Views
  • 2 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card