Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Can anyone please send me procedure to factory reset MR33 and MS120 switches so i can connect locally and access to see these are factory reset, I have tried already with (setup.meraki.com) & (wired.meraki.com) but not connecting.
Hi There,
I have one question if any one can help me with that, I have 50 CISCO switches (No IOS in any) with different models of 3560 and 3750 with G's and Non-G's, can any one tell me, is there any way to install IOS on all of them in same time i...
Hi Guys, I am having issue with this unit can you please guide me i cannot install IOS from rommon as ISR have no bootable file: Output is given below: File reception completed.Boot image size = 424692968 (0x19504ce8) bytesPackage header rev 1 struc...
My VS-card is keep crashing the IOS after using all the latest versions and older versions as well, can anyone suggest what i need to do? it is going till downloading mode when i press no for configuration. THEN AFTER THAT IT IS KEEP RESTARTING AND G...
You can just press the mode button on front panel for few seconds until it will show you the prompt:
flash_init
Type this command flash_init and wait for few seconds more, delete the files with command delete flash:config.text if you really want to d...
