Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,If I replace an internal AP MR 42, with an external MR74 with the 4 antenna's, will the MR 74 provide a longer range\better signal than the MR42?Thank you.
Hello,I have a 2960X trunked to a Nexus 9K.On the 2960 the trunk port amber and is:switchport trunk allowed vlan 10,100switchport trunk native vlan 100switchport mode trunkOn the 9K the trunk port is green and is:switchportswitchport mode trunkswitch...
Hi all,
I'm replacing a switch and see this route map on it, but I don't seem to see how its applied to anything. Can someone please let me know step by step how this is being processed?
# sh run | i route-maproute-map ospf-redist permit 10redistribu...
Hello,I would like to downgrade a Cisco Cat9300 switch. The switch is a single stand alone and is in "install mode". I would be installing the .bin file. What command should I use to downgrade the switch and how do I get it back to the current versio...
Hello,What are the commands I can use to copy the crashinfo_ext file to my tftp server?I need to find out why the stack member rebooted for no apparent reason.Thank you. 2960X-STK-01#dir flash2:Directory of flash2:/2 -rwx 111827 Dec 14 2022 12:25:05...
For the MR42 its using its internal antenna. If I replace it with the M274 it will be using it's 4 external antennas. The antennas are the omni directional ones.
I have new vlans and the same thing. Here's the output as requested.I have a 2960X trunked to a Nexus 9K.On the 2960 the trunk port amber and is:switchport trunk allowed vlan 170,949switchport trunk native vlan 949switchport mode trunkOn the 9K the t...
