Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am testing NCS 540.I connect it to ME-3800 and OSFP between both.I had problem with MTU.On the ME-3800, the MTU on the interface = 1530 (Header MPLS )On the NCS 540, I must configurer 1544 (1530 + 14).Have you an idea ?
Hello,I test one NCS 540 in my lab.I have 24 interfaces TenGiga , 8 twentyfiveGiga and 4 100gb.In documentation, i can see interface twentyfiveGiga are Ok for 1Gb.https://www.cisco.com/c/en/us/products/collateral/routers/network-convergence-system...
Hello everybody,
I would like understand this configuration :
interface Loopback0
description LOCAL MANAGEMENT ADDRESS
ip address 10.28.254.1 255.255.255.255
ip pim sparse-dense-mode
!
//
!
ip pim bidir-enable
ip pim rp-address 10.28.254.101 b...
Hello,
I have a network with MPLS/MP-BGP actived.
device = ME-3800-X
It's ok.
But today, I would like change the weight of some route.
But, route are well advertised but without the weight changed.
My config :
router bgp 65000
address-family ip...
HI,
- I have got 2 *4500x in VSS mode.
- I must configure static mac for NLB
I see in documentation > http://www.cisco.com/c/en/us/support/docs/switches/catalyst-6500-series-switches/107995-configure-nlb-00.html
Section multicast mode :
"When you ...
Hi Everybody, I configured the Twentyfive to ten .The interface 25 to 31 is now 10g. hw-module quad 0 location 0/0/CPU0
mode 10g
!
hw-module quad 1 location 0/0/CPU0
mode 10gBut when I insert a SFP 1g in Interface between 0 > 24 , it is OK, it...
hi philclemens.thank you for your reply.I just find this link on the web http://networkingbodges.blogspot.com/2019/03/how-to-use-25g-ports-in-110g-mode-on.html?m=1 I try it asapand reply to you for your information best regard
Hello,
Sorry for my late.
It's OK now.
I try to explain to you What I did.
Excuse me for my english.
On R1 (edge MPLS network) , this routeur diffuse the client's static route to MPLS whithout change the metric
Create IP SLA
ip sla 99
icmp-echo...
I create a route-map , SET-AS-PATH-VRF-TETRA
route-map SET-AS-PATH-VRF-TETRA permit 10 match ip address 99 set as-path prepend 65002 65002
But, i have a probleme with static route.
It's not supported.
sw_pn_nts141_ric(config-router-af)#redist...
