Network Security

So, I have gone through the quickstart guide for deploying the ASA 5506X.  As soon as I configure the FirePower services my ASDM stops working I get an error saying that ASDM cannot pull the configuration.  I know this is the SF module because when I...

Good morning, I'm trying to enable SSH on our ASA-5510 running the k8 file listed below. Using Cisco's configuration guide listed below I'm unable to create the crypto key because the "crypto key generate rsa modulus" command isn't showing up under ...

I am having problems with uploading the signatures for IOS IPS.  I am following the write-up provided at the following link. http://www.cisco.com/c/en/us/products/collateral/security/ios-intrusion-prevention-system-ips/prod_white_paper0900aecd805c4ea...

Hello, Other than configuring the inspect SIP parameter for the global policy of the firewall, is there anything else I need to configure to allow SIP through my ASA?  Do I need to configure NAT & ACLs?  I attached a diagram of what I think the topol...

Hi, I have the following problem : In my datacenter I have an Internet gateway, my ASA, a local network and another gateway to my private network (MPLS). The gateway to my network is on the inside network of the ASA. I also have a lot of servers on ...

Hello all,What configuration is required to allow an ASA CX to detect user devices?  Does it require some input from ISE or some other mechanism?  My specific question is for a pair of 5525-X firewalls.Any input is appreciated!Jim

Can anyone tell me how to find the right module to export from Defense Center for Vmware 6.0.0.1 that would include both a remote storage configuration and a scheduled backup profile? I have tried the "Initial Health Policy" but that did not include ...

Hello. I have recently purchased CWLMS-3.2-100K9 LMS 3.2 Windows100 Device  Restricted. I have the PAK key for this. I would like to get this registered online to get a license file. Can you please provide me directions for this.Regards, Mohit

Are there any known reasons as to why a firepower module would lock up fail-closed ? I've seen this happen to both a 5512-X and a 5525-X, the firepower module becomes locked up and the only way to allow traffic is to switch the service policy off in...

Hi I have a site which has a core switch connected to an ASA on a stick, so all traffic to the site passes through the core switch to the asa. The core switch has 2 voice gateways attached. After introducing additional users to the network, we have s...

Using the Firepower/FireSIGHT management center 6.0.0.1 in a virtualized implementation and hashing out a backup strategy. We have the Defense Center covered, and now trying to determine how best to back up the NGIPSv. The docs say there is no suppor...

Hi Comunity, I wanted to ask about an alert fired on the IPS. The signature has a high severity, but no actions were taken by the IPS. I checked the Event Action Filters and there is not any filter to avoid apply actions to this traffic. The alar...

I have zero experience with Cisco ASA's, although I do have extensive experience with other firewalls. My new employer is replacing 5520's with 5555's. Is there an upgrade tool or process that will import and upgrade the configuration from the 5520'...

hi, I have firepower install on vmware 6.0 an is running with out problem, but is for 2 sensor. can I upgrade the existing VM to 10 sensors without re-install?