Hi I have a 5506x and the SFR module that was stuck on status "INIT" - I have restarted / reset and reloaded the ASA itself without any joy I have uninstalled the SFR software "sw-module module sfr uninstall" However, when issue the following: sw-mo...
Network Security
Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
- Cisco Community
- Technology and Support
- Security
- Network Security
Options
- Mark all as New
- Mark all as Read
- Float this item to the top
- Subscribe
- Bookmark
- Subscribe to RSS Feed
- Threaded format
- Linear Format
- Sort by Topic Start Date
Labels
-
AAA
(9) -
Access Control Server (ACS)
(6) -
Access List
(4) -
ACI
(10) -
Advanced Threats
(1) -
AMP for Endpoints
(1) -
AnyConnect
(3) -
APIs
(1) -
Appliances
(18) -
ASA
(1) -
ASR 1000 Series
(1) -
Branch Router
(2) -
Buying Recommendation
(87) -
Catalyst 2000
(1) -
Catalyst 3000
(2) -
Catalyst 4000
(1) -
Catalyst 6000
(1) -
Catalyst 8000
(1) -
Catalyst 9000
(2) -
Catalyst Switch
(3) -
Catalyst Wireless Controllers
(1) -
Cisco
(1) -
Cisco Adaptive Security Appliance (ASA)
(9,635) -
Cisco Bugs
(59) -
Cisco Cafe
(25) -
Cisco CLI Analyzer
(1) -
Cisco Cloud Services Router
(1) -
Cisco Defense Orchestrator (CDO)
(150) -
Cisco Firepower Device Manager (FDM)
(812) -
Cisco Firepower Management Center (FMC)
(2,909) -
Cisco Firepower Threat Defense (FTD)
(3,163) -
Cisco Press Cafe
(1) -
Cisco Secure Firewall Device Management (FDM)
(48) -
Cisco Secure Firewall Management Center (FMC)
(255) -
Cisco Secure Firewall Threat Defense (FTD)
(307) -
Cisco Security Cloud Control
(16) -
Cisco Security Manager (CSM)
(3) -
Cisco Software
(19) -
CISCO START ANZ
(1) -
Cisco Threat Response
(1) -
Cisco Vulnerability Management
(46) -
Cloud
(1) -
Cloud Provisioning
(1) -
Cloud Security
(3) -
Community Bug or Issue
(1) -
Community Feedback Forum
(31) -
Community Ideas
(18) -
Compliance and Posture
(1) -
Crypto
(1) -
CSC Content with No Valid Community to Post
(1) -
CUBE
(1) -
CUCM
(1) -
Data Center Networking
(1) -
Device Admin
(15) -
EEM Scripting
(1) -
Emergency Responder
(1) -
Endpoint Security
(6) -
Enterprise Agreement
(1) -
Event Analysis
(265) -
FirePOWER
(1) -
Firepower Chassis Manager (FCM)
(2) -
Firepower Device Manager (FDM)
(16) -
Firepower Management Center (FMC)
(408) -
Firepower Threat Defense (FTD)
(221) -
Firewall Migration Manager (FMM)
(1) -
Firewall Migration Tool (FMT)
(38) -
Firewalls
(1,171) -
FMC
(1) -
General
(2) -
Guest
(1) -
Identity Services Engine (ISE)
(9) -
IE3300
(1) -
Integrated Security
(8) -
Integrated Security Architecture
(1) -
Integrations
(4) -
Investigation
(2) -
iOS
(1) -
IPS and IDS
(6,581) -
IPS and IDS1
(1) -
IPS-IDS
(1) -
IPSEC
(1) -
IPv6 Configuration
(1) -
ISE
(1) -
LAN Switching
(7) -
License
(325) -
MPLS
(1) -
Multicloud Defense
(3) -
Network Management
(94) -
Network Security
(2) -
Networking
(1) -
NFVIS
(1) -
NGFW Firewalls
(37,594) -
NGIPS
(1,874) -
Online Tools and Resources
(1) -
Optical Networking
(3) -
Optics
(1) -
Other Collaboration Topics
(1) -
Other Community Feedback
(4) -
Other Firewalls
(1) -
Other NAC
(18) -
Other Network
(2) -
Other Network Security Topics
(10,792) -
Other Networking
(9) -
Other Routers
(9) -
Other Routing
(24) -
Other Routing and Switching topics
(2) -
Other Security
(1) -
Other Security Topics
(18) -
Other Switches
(12) -
Other Switching
(4) -
Other VPN Topics
(1) -
Passive Identity
(1) -
Physical Security
(21) -
Policy and Access
(2) -
Prioritization
(3) -
Remote Access
(2) -
Room Endpoints
(1) -
Routing Protocols
(9) -
SD-WAN Security
(1) -
Secure Network Analytics
(1) -
Security
(4) -
Security Management
(645) -
Segmentation
(3) -
Service Providers
(1) -
Small Business Routers
(5) -
Small Business Security
(2) -
Sourcefire
(2) -
Support
(2) -
Threat Containment
(6) -
Threat Defense
(1) -
Threat Grid
(1) -
Unified Computing System (UCS)
(1) -
Voice Gateways
(1) -
VPN
(28) -
VPN and AnyConnect
(1) -
Vulnerability Management
(46) -
WAN
(8) -
Web Security
(5) -
Webex Teams
(1) -
Wired
(4) -
Wireless Security
(1)
- « Previous
- Next »
Forum Posts
Hi, I'm trying to upgrade my cisco 5512-x to new version, but when I assign new version with boot command and then rebooting the firewall, it cannot load new software, it gives below error and tries several times to boot again , then going to rommon...
Resolved! 5506-X Performance in the Real World
Hi All, I'm looking to roll out a few 5506-X's to our branch offices that have between 2 and 25 users on them. At the same time I'm looking to get them to join our OSPF backbone but I am a little concerned about their ability to cope with the enabli...
Hi My cloud based IP phones are not working after I installed Cisco ASA. Earlier there was Juniper firewall and phones were working fine. Any advice please. Thanks and regards, Ashok Kumar S
Dear All, I am using the ZBFW in my edge router. Users are behind firewall and NAT for the internal user networks configured on ASA 5510 which is running 8.4 image. I want to ssh to the zone based firewall inside interface in order to manager it from...
Hi, we have Cisco WLC 8510 and ISE appliance as RADIUS server, everything working fine but i found there is huge difference between WLC current client and ISE Dashboard Active Endpoints, its not properly sync.any help would be appreciated thank you,M...
Kindly help to configure IPSEC Tunnel on Cisco ASA-5585
I am trying to configure SNMP v3 in the system policy of a FireSight 6.0 MC. When I add the user and try to save the policy, I get the following webpage prompt: This policy includes access to port 161 (snmp), but no SNMP users have been added. SNMP ...
Hi all, have a quick question regarding Cisco IE 1.4 my client is on on the following Product : ISE - VM - K9version 1.4.0.253Role : standalone and has assign the following resources : 4 vCPURAM : 4096 MBDisk : 220GB however he is seen the following ...
I have a customer who has just purchased a 5512X with Firepower, and the Firepower management centre. This my first exposure to Firepower. But when I tried to register the ASA with the FMC got this message "device software version lower than '5.4.0' ...
Is there a migration tool or a command I can use to modify an exported file package from 5.4 to install on a new 6.0.1 sensor?
Hi, asa (route mode ) -----sniffer-------router---wan And in the sniffed traffic i can see source 10.0.15.121 and destination is 10.10.0.50 why i can see a private ip address? Thanks
Hi All we are keep on getting this below error every day. Please help us to identify the issue behind this. Module Name Test Name Time Description Value Units Status DeviceProcess Status Process Status 2016-03-10 01:04:34 All processes are running c...
Hi guys, today one of our Sourcefire sensors (3D8130) is giving us a hard time. The error in Defense Center is Module Inline Link Mismatch. That led me to believe that probably the auto-negotiation is not working anymore. When i went in to disable ...
hi, please help me about cisco firesight management center after login cisco firesight management center dashboard is not showing anything, its blank totally.
Learn, share, save
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Unanswered Topics
| Subject | Author | Posted |
|---|---|---|
| 07-22-2026 05:00 AM | ||
| 07-16-2026 06:39 AM | ||
| 07-15-2026 08:48 AM | ||
| 07-13-2026 11:05 AM | ||
| 06-24-2026 08:00 AM |
New solutions
Top Solution Authors
| User | Count |
|---|---|
| 2 | |
| 2 | |
| 1 | |
| 1 | |
| 1 |
