Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Hi All , I have Cisco 5525 firewall and use FireSight to managed it , kindly i need to deny unauthenticated domain users from access to internet , Could you help me ? Regards,

amhabdallah by Community Member
  • 1185 Views
  • 4 replies
  • 0 Helpful votes

Hi Team, May I seek your help on subject-above. We have HA ASA5510 with software version 8.0(3) with 256MB memory. We will upgrade the software to 8.2(5.59). Does it have an upgrade-path [8.0(3) > 8.2(5.59)]?Also, Is it possible to upgrade the memory...

Mady by Level 4
  • 1027 Views
  • 3 replies
  • 0 Helpful votes

i need to know FP7120-K9 support the below or not :- 1) Support encryption between the network intrusion detection sensor and its management or event collector station. need Licence or not ? 2)Reassemble fragmented packets and reconstructs stream to ...

I have recently purchased a Cisco ASA 5506-X with FirePOWER Services for my home office. I have configured the firewall and have already deployed it. However, I am unable to access the FirePOWER Services configuration through ASDM and, therefore, una...

I have an ASA 5506x which has ASDM 7.5.1 . Unfortunately the ASDM has a bug in this version preventing me from using it to set up my routing ( https://tools.cisco.com/bugsearch/bug/CSCuw09242 ). I cannot download a newer or older version and I cannot...

Layne Ivy by Community Member
  • 1343 Views
  • 4 replies
  • 0 Helpful votes

Hi All, Please advise on the below Say for ICMP, we have enabled inspection, how the firewall does the stateful inspection? From other blogs, it seems the ASA will create a Dynamic ACL with wildcard source address.  Question: 1)If wildcard source add...

Hi My UK (SKY) Fibre provider requires MER authentication so I need to have my ASA 5505 to perform that. Even though ASA 5505 supports DHCP with option 61 it appears that you can only use either MAC close or the default settings "Cisco-<MAC address>-...

pantelis1 by Level 3
  • 1310 Views
  • 3 replies
  • 0 Helpful votes

I've got a asa 5508-x(9.4(1)) on a 100Mbit ethernet connection.  Behind the asa are about 120 clients, 90 of those being actual computers.  The asa has 3 site to site VPN tunnels running voip traffic and linking branch offices.  Overall things are wo...

swits0181 by Frequent Visitor
  • 2277 Views
  • 14 replies
  • 0 Helpful votes

I am trying to figure out how to create an etherchannel with sub-interfaces on an asa 5520 running 8.4.1 code.  It doesn't seem to allow me to configure any type of sub interface on the port-channel or anywhere else once I create it.  Does anyone kno...

corey.book by Visitor
  • 19085 Views
  • 5 replies
  • 0 Helpful votes

Dear All, Is there any chance to disable the implicit rules, which apply the forwarding from higher-security level to a lower-security interface for an ASA 5505? I have more than one inside LAN and I don't want to add an explicit deny rule for every ...