Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Hello, I am currently trying to design a solution for the following example. I have two groups of Billing servers. A Primary group and a back up group. These groups are also in different locations, at each location I have an ASA 5508-X in front of th...

I have URL filtering set up on FireSight and my ASA 5525-X.  I have noticed that it does not block unwanted pages.It shows up in Defense Center events as "interactive block with reset", but the page is actually never blocked.  It appears to be trying...

Hi,I have ASA-SM pair (WS-SVC-ASA-SM1) in active/standby failover mode currently running 9.0.4  (asa904-smp-k8)I am upgrading to 9.4.1 and first attempt failed giving the following errors for every interface on every context when reloading the standb...

All  This is my first time configuring a ASA and im facing some issues. It seems like im trying to do something basic but i cannot get it to work how i expect. I have multiple public IP addresses say /29 and im trying to assign them to an interface. ...

benford01 by Level 1
  • 1195 Views
  • 6 replies
  • 0 Helpful votes

Hi, Please i will sitting for one of the ccnp security exam and i want to know what next to do after you configured the ASDM simulation part. Is there a place to save your configs or ???I found out i scored a lower score during my CCNA security as a ...

cleomarth by Level 1
  • 384 Views
  • 1 replies
  • 0 Helpful votes

Hi,I have issue with with small 8-port switches and port authentication with EAP-TLS.  Error:  %AUTHMGR-7-RESULT: Authentication result 'no-response' from 'dot1x' for clientError:  %AUTHMGR-7-RESULT: Authentication result 'timeout' from 'dot1x' for c...

I've been stuck with Fortigates for awhile and had to help a customer with their ASA setup.   They state that Guest interface can reach inside hosts/servers.. And when I check, I see that we have no NAT statement between Guest and Inside networks.   ...

azore2007 by Level 1
  • 1127 Views
  • 5 replies
  • 0 Helpful votes

Hello All, I have two default routes on ASA pointing to two different ISP s with different metrics.The hosts pointing to the default route with metric 1 are able to access the internet to and fro,however the hosts pointing to default route with metri...

mudasir05 by Level 1
  • 1264 Views
  • 7 replies
  • 0 Helpful votes

Hi guys,I am new to this group. I have a question and believe it is related to the firewall. I need 443 routed internally. The connection is working with 80 but not 443. Please check the picture attached. The command existing in the firewall is acces...

venkat257 by Level 1
  • 956 Views
  • 6 replies
  • 0 Helpful votes

I would like to allow RDP in from only a specified IP.  Right now RDP is not allowed from any IP, but SSH is allowed in FastEthernet 0/0 is my WAN interface interface FastEthernet0/0 ip address dhcp ip access-group Block_Stuff in!ip nat inside source...

Review Cisco Networking for a $25 gift card