Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey guys, I am trying to consolidate 2 different firewalls into another ASA 5520 active/standby firewall, and only have 1 interface available, I wanted to make sure that I can use sub-interface for site-to-site VPN, anyconnect, and also another sub-i...
Guys, I need some help to see why my Anyconnect clients is unable to connect to 1 particular inside network, I would like to know what to look at first. I ran out of ideas and would like to know where should I start with resolving this. How should I ...
Guys, I am trying to create a guestwifi, but it does not seem to work, i will post my configurations below. Please let me know any additional information.ASA Version 8.2(1)interface GigabitEthernet0/3 nameif guestwifi security-level 5 ip address 192....
Guys,I have an existing network that I would like to move into a DMZ on my ASA 5520, what is the best method? the gateway is currently on the core, I was wondering if I could move the gateway to the interface of the ASA?
Hello, I have 10Gb fiber cable that we do not need, I was curious to know if I could use a 1Gb SFP module instead of 10GB module? We do not want to have to pull new fiber, or pay for an additional 10Gb module if we do not have to. Thanks,Chad
Thanks John, I did see that and I just entered the command you recommended, I will have my team to test, while I wait I am going to find some videos about natting. I will let you know, thanks again.
John, I did not include 1, I thought the global nat statement would have covered the NAT (i guess not), but I do no have a NAT config for that network, can you give me a simple command to show me what it should look like?
Thanks John, The devices connects to the AP and gets a DHCP address successfully from the ASA, but are not able to access the internet through the outside interface. What do you mean do I have a NAT device?
