Network Security

Hi,I am little confused with different models of Cisco ASA Firewalls.  I am trying to understand the real benefit of ASA Next-GEN ASA Firewalls. I understand the next-gen has visibility up to layer 7 but:- with CX the previous gen of ASA Firewall had...

Hello, everyoneI have been trying static nat on a ASA 5510 8.2(2), but it is not translating.  Public IP: 1.2.3.4Private IP: 192.168.11.18 static (inside,outside) 1.2.3.4 192.168.11.18access-list outside_access_in extended permit ip any any sh xlate ...

hey guysi have a server which accepts traffic on one port inside my network and clients outsides needs to access this server. the nat and accesslist works fine but there is a timeout issue and the connection fails ... note that without the asa client...

Hi all,Does it possible to configure ASA failover with different IPS module configuration because we have:  ASA 5585-X with FirePOWER SSP-10 and  ASA 5585-X with IPS SSP-10 Thanks, 

Good Morning.I've a great problem with my new ASA 5515-X Configured in Active/Standby Failover.This is a company that have 8 remote branches connected via VPN Site-to-Site with our ASAs on the main site. All the remote branches have one or two ASA (c...

Brief background.  I took a position with a new company and am trying to clean up the network(HUGE TASK). Initially I'm locking down the equipment, and my question is on ASA/PIX firewalls regarding SNMP community strings. I set the RO community, ques...

Hi all, we are looking at purchasing a Cisco ASA 5512-X IPS Edition but we are having a very difficult time trying to figure out what software and licensing we need for it.  Can someone please answer the following questions?1. I see the part number f...

I'm newer to ASA's and I have the following scenario:External users need RDP access to an internal server, so they need to hit a public-facing IP that gets translated to a private, but I also need to NAT the external users public IP, so that I can en...

Rather unconventional design that i am trying to test with transparent mode firewall.... attached diagram Clients [VLAN 100] connected on L3 Switch with SVI as default gatewayFirewall using one physical port which is sub-interfaced with INSIDE-100 an...