Where do I find the zip file disable_sslv3.zip mentioned in bug CSCur29069? 2) Extract attached disable_sslv3.zip to CSCOpx\bin directory. There's nothing attached to the bug and I also do not find it at CSM software downloads.Can anybody help...
I have the below config on ASA 8.0 I need to convert it to 9.2name 10.2.17.80 BV-DVRname 10.2.13.80 SE-DVRname 10.2.23.80 ES-DVRname 10.2.10.80 NW-DVRname 10.2.10.81 NW-DVR2name 10.2.1.76 C-DVR1name 10.2.1.78 C-DVR2name 10.2.1.80 C-DVR3name 10.2.19.8...
Hi There, I have an issue with a Cisco ASA firewall showing TCP reset-o and deny messages for server replies for hosts which have initiated the connection. the firewall says it can't find the connection on the table but it does show the connection go...
i have cisco asa5512-x fw ed with basic license. i need to add IPS to it.do i need module or only license or both? and i have another cisco 5520-k9 with security plus and also need to add IPS to it?
Hello All,May I know if Sourcefire can inspect traffic tunneled in EoIP ? We have a wireless guest network traffic which is passing through EoIP tunnel (between WLC and guest anchor controller), is it possible to inspect such encapsulated traffic ? R...
hi all,i'm going to configure SNMP on our ASAs to be monitored on solarwinds' orion.could someone advise what SNMP traps i can enable without affecting the ASA's performance (not too chatty) and just for basic monitoring stuff?also, are these the lin...
I originally setup my phone proxy using this guide: http://www.cisco.com/c/en/us/td/docs/security/asa/asa91/configuration/firewall/asa_91_firewall_config/unified_comm_tlsproxy.html Phone would register but there was no audio. Along with allowing tftp...
Hi, I need to connect/protect interfaces with access-list and there i have some problems that i cannot solve, getting syn attac: Interfaces have same or different security-levels, but i don't use same-security-traffic permit inter-interface, because ...
Hello,I am replacing FWSM with ASA module, I have used the migration tool and migrated the configuration my concern is I have very critical server which have a zero downtime.I am planning to replace both at a same time but there will be a situation w...
Hi,We have a ASA 5525 with multiple contexts running 9.3(1). We are having troubles routing IPv6 traffic between contexts.Assume: Internet ---- <ASA "Internet" Context> --- <ASA "Customer A" Context> ---- End HostWe have configured static to route fr...
Hi, Cisco Support Community I want to configure an ASA to facotry-default using the following commands.# configure factory-default# wr mem But when I use above commands, ASDM is to be unset !How can I set ASDM remain factory-default ? I don't want to...
Hi all, I hope everyone is doing good. I've been having trouble to config my DMZ lab. I use Packet Tracer 6.1,and the firewall it provided is ASA 5505. The 3 interfaces on the firewall all use DHCP addressing. Due to the lab requirement, I ...
Hello Dear Group I have an ASA5525, I need to renew the license that has been registered for Anyconnect VPN clients, but I forgot the private key that I have used for license registration. is there any solution to retrieving the private key because t...
