Network Security

I have 2 internet feeds, I call them Internet-WAN1 and Internet-WAN2I also have 2 VLANs, VLAN-A and VLAN-B With 1 ASA5515, how do I set up so that clients in VLAN-A can access internet via WAN1 only ? And the same for VLAN-B to WAN2 ?I'm familiar wit...

Hello,This is my first time working with the X genertaion of firewalls.  I note from an output of show interface ip brief I get an additional 4 interfaces along with the gigabitethernet interfaces, namely: Internal-Control0/0        127.0.1.1       Y...

I made a small prod network with 3 internal segments and the outside interface.  I am routing entirely on the ASA 5525xI should have done the routing on L3 switches at a minimum, but I'm trying to see if I can stopgap the pain by disabling traffic in...

Hi guys,I have one ASA 5505 running 8.4(2) with two interfaces:5505# show ipSystem IP Addresses:Interface                Name                   IP address      Subnet mask     Method Vlan2                    outside                80.82.x.y    255.25...

I have ASA 5512 configured like below:g0/0 : outside --->  security 0, connect to the internet via GW router, private IP /30, no NAT (NAT is occur on the GW router)g0/1 : inside1 ---> security 100, connect directly to LAN 10.x.x.xg0/2 : inside2 ---->...

HI,I really need help with this  and I read on a lot of forums.static (Inside,DMZ) 192.168.21.0 192.168.21.0 netmask 255.255.255.0I am not sure how to that in 9.1.I looked everywhere, but no luck.Alsostatic (Inside,Outside) tcp interface 2326 192.168...

HI Guys , I have a problem in converting the static nat in fwsm to ASA 8.3 or later.I have a fwsm which we are migrating to ASA, FWSM has a below static nat statement, static (v123,v546) 10.10.10.0 10.10.20.0 netmask 255.255.255.0When I see the trans...

Hi All, I have a scenario as follows, clients ---- ASA ---- Internet                 |  DMZ interface              Web Proxy My clients on the inside needs to get redirected to a web proxy server which is behind the DMZ interface. Now WCCP works fine...

I have ASA5525-X and I can't save configuration because of flash memory doesn't let me. I tried to format from rommon but results are same. Is there someone who can help me to fix a problem?

Hi Team, How to configure VRRP or HSRP with multiple vlans in a LAN network with the internet going through ASA firewall.

Internal 192.168.0.0/24How can Internal LAN to be NAT to the Outside as different range of IP address? 192.168.0.0-------->NAT------------> 10.215.0.0ASA ver 8.0(3)is it possible??