Network Security

Hi,No matter how the clientless vpn is configured I get a login failed after trying to login despite the details being correct, If anyone has encounterd this before any help would be great.Thanks The attachment is syslog output during an attempt, it ...

Confused on the ACL, when to use tcp host and IP host in the access list I.e permit tcp host or IP host.

I tried to deploy the new ASAv on my VMWare Workstation 10 but importing the ova file fails with "Error importing OVF: Line 330: Unsupported element 'Property'".Has anyone managed to get it running?

I am going from a pix-515e to asa-5512-x.   I used the wizard for the initial setup.  I then set the interfaces the same, objects, nat rules, routes, ACLs the same as in the 515e (except for the outside interface ACL where you use the inside address ...

I have an ASA5510, i configured an Outside, 1 DMZ and 2 100 security level interfaces. I can ping and have fluid traffic between DMZ and 1 interface 100 security level (Inside), but don't have any kind of traffic between DMZ and the other 100 Securit...

Good afternoon gentlemen I need to configure rate-limits to customer Internet traffic. Customer has 3 traffic classes (VPN, mail and website), each one with its respective input and output rate policing. I have to perform this configuration in some p...

Hi -  I am curious to understand how the SSL/HTTPS inspection is designed to be handled in Cisco ASA Firewall.What all I know is that, for SSL inspection the firewall has to de-crypt and again encrypt the traffic passing thru the firewall. Does this ...

Dears, I would like to implement the below design , and im wondering if its going to be valid. PC(Access vlan 10)-----------SWITCH(SVI Vlan 10 , Vlan 20)------Trunk-------Bridge group 1-----ASA(Transparent)--Bridge group 1-------Trunk----Switch(SVI v...

I am running 4.0(7) and we are experiencing some issues with downloads - specifically http downloads. Anything with an https link works fine.Looking into the config on the FWSM i see that under the global_policy we are inspecting httppolicy-map globa...

Hi, My ASA5505 start acts strangely in the ASDM. When i starts create Network objects and Network objects group, it often failed -Actually what i am trying to do is to deny connection  to/from Adverstment servers, it is supposed to an easy task to do...