Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Hi ,all ips 4240 , boot  screen  display  this information again and again , it’s not work when i try to copy a new image to flash card from tftp , test the flash card is ok ,so what should i do to fix it CISCO SYSTEMS Embedded BIOS Version 1.0(11)2 ...

wowwangccie by Community Member
  • 1923 Views
  • 1 replies
  • 0 Helpful votes

What is the difference in the following:access-list 100 permit tcp any any a.b.c.d 0.0.0.255 w.x.y.z 0.0.0.255 eg 22access-list 100 permit tcp a.b.c.d 0.0.0.255 w.x.y.z 0.0.0.255My question is: does the 1st one allows only ssh traffic?does the 2nd on...

jonl711 by Level 2
  • 1661 Views
  • 1 replies
  • 0 Helpful votes

Hi Everyone,Need to confirm below is the right way to make changes in firewall when they are in multi context mode--Active ,Active Need to add ACL in 2 firewalls.Say ASA1 has two contexts admin and aWhen i logon to say IP 192.168.1.1  i go to ASA1/ad...

mahesh18 by Level 7
  • 999 Views
  • 2 replies
  • 0 Helpful votes

Hi,my 5510 is running 8.3(2)27 and i want to go to latest 9.x release to get the NSEL feature to provide periodic byte counters.Is it possible to go directly to 9.1.2 or do i have to make all the intermediate steps to 8.4 and 9.0.I saw some releases ...

xboessler by Frequent Visitor
  • 1263 Views
  • 3 replies
  • 0 Helpful votes

Hi, I am configuring a pair of 5525X's running 9.1, migrating from some 5520's running 8.2.5, so the NAT portion obviously going to be different.Topology is straight forward.  4 interfaces, Inside, Outside, DMZ1 and DMZ2.  For some reason, all 3 inte...

rrfield by Level 3
  • 2307 Views
  • 2 replies
  • 0 Helpful votes

User is going to place a "three leg" 5505 ASA on site's existing LAN.Two PCs, one in each firewall's DMZ and PCN network will use a NAT'ed IP address that is on site's LAN.Question is: will the site's core layer-3 device require a "reverse" route poi...

KSVY_KSVY_2 by Community Member
  • 1813 Views
  • 5 replies
  • 0 Helpful votes

Good morning.  I am having some trouble setting up a new ASA 5505.  I finished the config and before I put the ASA into production I decided to run the packet tracer on the ASDM.  the test packets seemed to pass fine through my ACLs however keep gett...

bmhoskinson by Community Member
  • 1117 Views
  • 3 replies
  • 0 Helpful votes

Hi,I am experiencing issues with the Auto Update feature for signature definitions for the 5525-X IPS module. I am using Cisco-Server auto-update with a proxy server (I am running the latest Engine Version).# sh verApplication Partition:Cisco Intrusi...