Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

                   hi CSM guys,                                             I am a new user to CSM security manager . Currently we have asa 60 ASA 5505,5510 5520 and 5-10 IPS modules. I would like to know CSM 4.2 version  would be good enough to mana...

rinoj2009 by • Community Member
  • 1964 Views
  • 1 replies
  • 0 Helpful votes

Resolved! asa5510 asdm issue

Hello everyone,I am getting the following error when i try to use ASDM. "Your ASA image has a version number 8.2(2) which is not supported by ASDM 6.1(3)." I looked at the following link http://www.cisco.com/en/US/docs/security/asa/compatibility/asam...

lawsuites by • Level 3
  • 2537 Views
  • 5 replies
  • 0 Helpful votes

I have a RV042 in one office and we are moving to a VOIP telephone system.They requested a bunch of ports open, and I wanted to make sure that only thier IP addresses get into the local net.I setup port forwarding to forward ports internally to their...

Anthony Wood by • Community Member
  • 4184 Views
  • 9 replies
  • 0 Helpful votes

Hi Folks,Just want to check with you about memory utilization on the Asa 5510 ..Free memory: 19%Used Memory: 81%Is this normal? Because we hade a problem this morning and the memory was at 100%..Device Manager version 6.1(5) 57Hardware:   ASA5510-K8,...

Not sure if this is a voice question or a firewall question.I am trying to configure my ASA 7.2(4) to inspect SCCP traffic from a CUCM v7.I have been advised that the ASA device needs to support the version of Skinny I am running.Two Questions:What v...

Some of my users were complaining their software was not working correct. It retrieves file from a remote host and then constructs a model from these files. Retrieving and constructing behind our ASA5510 resulted in a corrupt model while the same act...

mazzzterrr by • Community Member
  • 2340 Views
  • 1 replies
  • 0 Helpful votes

I understand there is a 90 day trial version I can't find it on Cisco.com.I have a CCO.Is it np longer available due to EOL?SteveSent from Cisco Technical Support Android App

aksteve11 by • Community Member
  • 1070 Views
  • 1 replies
  • 0 Helpful votes

I have a problems with one SA520W.The LAN port don't work correctly. If i connect PC directly via ethernet cable (i try 2 different cable and 2 different PC) the DHCP don't assign an IP. If i reset to factory default and manual insert IP (192.168.75....

tcamatta by • Level 1
  • 1089 Views
  • 2 replies
  • 0 Helpful votes

I know this has been asked before and I have looked through dozens of forums trying to get this to work.Here is where I am at.  I can get out to the internet.  My internet works.  However port forwarding does not work.  I want to port forward from th...

Review Cisco Networking for a $25 gift card