Network Security

Engage with peers and experts on network security topics such as FTD, FMC, FDM, CDO and ASA.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

                   Hi Everyone,I have ASA connected to inside and DMZ  vlan.DMZ Vlan has connection to Layer 3 switch which is on inside network.OSPF is running between ASA and DMZ switch which  is directly connected.Lets say if DMZ switch has some n...

mahesh18 by Level 6
  • 4215 Views
  • 7 replies
  • 0 Helpful votes

When a company switch ISP provider and receive a new block of public IPs, what is the best practice to reconfigure the ASA, its outside interface, DNS, default route and other services like SMTP, sftp with minimum downtime? Is there anything that I c...

I was handed a firewall ASA 5520 but without external flash, I want to confirm that  the ASA at least boot from rommon mode boot must have the external flash connected? I connected  to power and I connect it by the console port it did not show any bo...

Hi,our FWSM (in 6509) is not comming up, when tried to sesssion up using "Session slot 1 proc 1" command,It is giving error , "Tyring 127.0.0.11 .....connection timed out remote host not responding".In "show mod" command output at Switch in IOS conso...

                   hii have csm 4.3 and i did deploy to file and it was a success , when i am doing deploy to device i am getting an error saying:an error response from the device prevented succeful completion of this operation. the device provided t...

brinat by Level 1
  • 1084 Views
  • 0 replies
  • 0 Helpful votes

Hi guys,I have setup cisco ASA5520 with SSM10 on Transparent mode. I am able to access ASA5520 via both CLI and ASDM.However, i am only able to access SSM10 via CLI only. Whenever i tried to access using ASDM, i am getting "Unable to launch device ma...

Review Cisco Networking for a $25 gift card