Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We're in the process of moving to ISE and our supplier has asked us to add AAA commands to all of our Access switch interfaces to allow for profiling of the network to commence. The issue I'm having is that so far out of 22 stacks I've added the comm...
Currently our WAN interfaces go directly into our VSS 6509 chassis. We purchased a pair of Palo Alto 5250's to sit between the WAN and 6509 chassis. The setup is a pair of 10gig interfaces in a Port channel up to the Palo's, which is all configured a...
We've just started to implement changes on our switches so we can use ISE for authentication and on a switch stack of 6 switches I logged on did int range gig1/0/1 - 48 and copied the below config to the switch.
Switch 1 was fine and took approxima...
I'm very new to BGP and have been using GNS3 to help me understand how to configure BGP on Cisco IOS. See below what my test network looks like and I've attached the configs from the 3 devices.
I'm seeing the 3 VLAN's on the LAN Core in the Gateway...
Thanks for the information When I did a sh tech and ran it through the CLI analyzer the output didn't give any specific bug information just a danger IOS CPU usage is very high. I've had a look at the bug and if it is what's causing the issue how do ...
SebThat worked a treat and the difference is massive.I'm assuming the reason those two commands cause the issue with the switch is that every command for every interface is sent to TACACS for the OK for that user so it just gets bogged down particula...
The existing AAA is belowaaa authentication login default group tacacs+ localaaa authentication enable default group tacacs+ enableaaa authentication dot1x default group ise-groupaaa authorization config-commandsaaa authorization exec default group t...
