Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

I'm currently having the following version on my ASA5505.ASA 8.3.1  ASDM 6,.4.5 I'm seeing the following new versions on support site and i would like to upgrade to the latest versionASA 8.3.1  ---> 8.4.4.1.EDASDM 6,.4.5 --> 6.4.9.103My question is 1...

Hello All,I'm going to be configuring failover with FWSMs for our 6500 at my job and I have a config question. There is one current 6500 chassis with 2 FWSMs installed. They are both online but currently since failover isn't setup, only one FWSM is a...

On the ASA5505's, is it possible to get the features of the Security Bundle on a user count less than unlimited. Basiclly I'd like a 25 or 50 user ASA with the ability to have an inside, outside and DMZ I'm pretty sure units without the Security Bund...

codewize by Level 2
  • 1983 Views
  • 3 replies
  • 0 Helpful votes

The description of this signature says "This signature fires upon detecting out of old ack packets."That doesn't even make sense. Is that a type-o or something?What is it about Ack packets that causes this signature to trigger an alert?

Hi,I'm replacing a router with an ASA. Is there any way to implment the effects of this statement on an ASA?Note there is no Websense or other external device, just these statements alone, so they might not do anything. ip urlfilter allow-mode onip u...

lcaruso by Level 10
  • 1258 Views
  • 2 replies
  • 0 Helpful votes

Hello all!I am new to the forum, and new to the world of Cisco, so please go easy on me! I have been tasked with replacing our company eSoft router with a Cisco ASA 5505 with the upgraded security license.   I have been working on the configuration f...

weedtarded by Community Member
  • 11171 Views
  • 7 replies
  • 0 Helpful votes

Hi guys:I got a question regarding on how the failover activate, as far as I know there are only 3 ways to trigger the failover:1.- With the command "no failover active" on the Active device.2.- If one of the interfaces (INSIDE/OUTSIDE) is down.3.- I...

Review Cisco Networking for a $25 gift card