Network Security

I wanted to increase memory from 64 to 128.  I removed 2x32 meg chips and added 1x128.  Show Mem command still shows 64 meg installed.  Do I need to have the second bank filled also before Pix will see the 128?

Is it possible to provide a single sign on service for virtual HTTP on an FWSM, where I have ACS 4.2 and win2k8 domain?The application is to allow a client full access to the secure network (inside) behind the FWSM where the client is on a wireless n...

HelloI have a pair of 6509's with an fwsm in each.FWSM in Switch 1 was activeFWSM in Switch 2 was standbyFWSM in switch 1 failed so fwsm in switch 2 became the active firewall, however, no traffic was being passed.The status was as follows in the sec...

HelloI have question about FWSM ( WS-SVC-FWM-1)  throughput. I have context type transparent   on my Cisco 6500.When I send  about  10 Gb/s allowed data via this context traffic above 5,5 Gb/s ( max throughput firewall card )  will  be dropped ?Regar...

I am looking to see if the Cisco ASA 5500 platform running ver 8.2 has support for RPC dynamic port filtering? So basically can I enable TCP 135 in an ACL and will the application policy read the RPC calls and dynamically open the ports being set in ...

I currenty have a pix and would like to import some of the commands over but I am having a hard time with converting this nat rule. How would this nat rule be implemented on an ASA.nat (inside) 1 0.0.0.0 0.0.0.0 0 0static (inside,outside) 10.199.0.0 ...

Has anyone noticed issues with icmp inspection not working on certain conversations,or can someone think of another explanation for this?%ASA-6-302020: Built outbound ICMP connection for faddr XX.XX.XX.XX/0 gaddr YY.YY.YY.YY/1341 laddr YY.YY.YY.YY/13...

Could any expert here able to give me a hand ? I'm totally new on asa 5505, because of my previous one broken.I would like to set this up with some static NAT rule located on 192.168.2.0 segment and two segment of internal network able to access Inte...

Hello everyone,Do you know someone if the NAC Manager supports SSO and LDAP authentication with Windows 2008 R2 Active Directory?Thank youMichal

Hi All,Please help me to configure FWSM in my VSS environment. I have two 6509s in my network, VSS is running in between. Each switch contains an FWSM module. I want to configure these modules with failover. What all things i need to consider before ...

I am able to access the ASA5510 device (8.2(2)) via ASDM (6.2(5)) from a PC at home (Windows 7, IE8, most recent java) but am unable to connect to the device from my work PC (also Windows 7, IE8). Each time after succesfully connecting to the VPN, my...

Please find my ASA config.hostname fw!interface Ethernet0/0 nameif NC_OUTSIDE security-level 0 ip address 192.168.36.250 255.255.255.0 !interface Ethernet0/1 nameif JA_OUTSIDE security-level 0 ip address 192.168.127.250 255.255.240.0 !interface Ether...

I ran the Output Interpreter on our 506e and got the following:WARNING: The IP address, 6x.172.214.193, of the 'outside' interface overlaps with the static defined by:     'static (inside, outside) 10.2.28.0 10.2.28.0 netmask 255.255.255.255'.Can som...