Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

i have come across statements which involve communication issues passing via ASA/PIX being resolved after translation was cleared.same has been read for some routers also. I have an understanding that translations are usually cleared before we do a n...

suthomas1 by Level 6
  • 723 Views
  • 4 replies
  • 0 Helpful votes

Hi allI'm having some trouble setting up an active ftp session from inside to outside.I've read the other topics on the forums, but i can't figure it out myself.I created some acl's and port forwards, i also configured the inspect FTP in the global p...

On the IPS 4260-k9 under the cisco.com server settings the url is the default but there is a section that states Username and Password. I put my CCO id information in this location. And when I go to the url that is in there it brings me to a page tha...

Hello Guys,S.O.S....Right  now, every one can go to ASA FW via browser (ip address specified on my  outside interface) and connect, download certificates and AnyConnect  client with assigned uname and password.What i am trying to do is:Configure  my ...

I have my PIX 515 setup to sync time to one of the Naval clocks, and it seems to be working fine. I would like to have my Windows Active Directory server sync its time to the PIX what additional steps do I need to take?

jcapaul by Level 1
  • 437 Views
  • 1 replies
  • 0 Helpful votes

We have several partners in different countries who are using overlapping subnets on their switch hardware.  we have to manage all the partners hardware from our netmanagers which are installed behind an ASA5510 firewall. We have a single port to the...

jschweng by Level 1
  • 771 Views
  • 1 replies
  • 0 Helpful votes

I have to make several changes in the configuration due to our company switching Internet Service Providers.  Is it best to do a "show run" at the command line, then just copy/paste new config into the ASA?  Or is it better to run the "more system:ru...

waldronks by Level 1
  • 673 Views
  • 4 replies
  • 0 Helpful votes

Hi,I want to upgrade the IPS module in an ASA 5510 and have a few questions. The AIP-SSM is running 6.2(1)E3 479.0 and I have a valid CCO account etc for this.Does the Software version on the ASA matter?When I look in software downloads < IPS there a...

kinskins01 by Level 1
  • 19261 Views
  • 5 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card