Network Security

What is a good client to run on the clients for accessing the server

Hi,We use two asa's in loadbalancing. Users use the loadbalancing fqdn name to connect. This works fine until we push new client anyconnect software, that the connect to field changes from the fqdn to the appliance ip address where the client downloa...

Hello,I'm upgrading my ASA 5520's firmware from 8.0.3 to 8.0.4.48 (not 8.0.5 yet) and I have upload this and the latest ASDM file 6.2.3. How do I tell the ASA to use the new firmware on next reload? I read that the ASA follows configuration order to ...

Can VPN 3000 series concentrator support 32bit Windows 7

Hi all:I wanna do a password recovery on a PIX 520, I read the document with the steps I have to follow but I dont understand how I have to use the rawrite.exe program.I tried it from Windows Explore, from ms-dos but without exit. How is the procedur...

Configure

I keep receiving the following msg every 10min."Deny inbound UDP from 172.16.30.35/137 to 192.168.1.1/137 on interface inside"I have discovered the 192.168.1.1 ip is located in my ARP Table with the interface set to STATE.Please help.

Is there any way on a ASA 5510, v.8.0(4), to automatically resolve IP addresses in syslog messages? TIAKen

Last night I upgraded an ASA 5520 from 8.0.(4) to 8.2.1 it booted fine and seemed to pass traffic fine however any incoming static nat translations didnt work even though they showed up in the ASDM, should I have made any config changes prior to upgr...

I am getting the Warning Window "The Startup Wizard will not able to allocate ASA traffic to this sensor for inspection. ASDM must be upgraded to a newer version before you can allocate traffic using this wizard." everytime I launch Startup Wizard fo...

Hi ThereCan't find any information regarding this feature, what I have found states that it is a feature, which only is supported when Your context is running in transparent mode, is that true. ???Thanks in advance.

Traffic across firewalls passes through the access rules. In PIX devices, single ACL is matched to a traffic, whereas in Cisco ASA 5500, traffic is matched to two ACL's (ingress and egress ACL). I have come across these in the below Cisco NSEL docume...

A problem wherein a https website hosted inside one of the dmz segments is not working from the web.I did some captures but they dont let me anywhere.Internet--Router--Level1Firewall--Level2Firewall(module on 6509)--Router(leaseline link)--Router(LL ...

dear all,i would like to have a support to allow traffic of PPTP and GRE ports

I am running into an issue where one of the tcp services going through my PIX running 8.0(4) sends packets AFTER the specific connection has timed out. The result is that it reports an error on a packet for a non existing connection. Is there a way f...