Network Security

Are there any gotchas when trying to configure this?I tried to configure this using:global (external) 1 x.x.x.66nat (inside) 1 0.0.0.0 0.0.0.0And I was not able to ping any external devices. However, prior to this configuration, we had another device...

Hi We have site2site VPN with ASA 8.03 and I configured the QoS on ASA outside interface. But there is no traffic mapping the QoS, here is my QoS setting and show service-policy output. In the output, there is no traffic mapping the class-map ERP. A...

Hi all, today we had a failover event on a pair of asa5505's running 7.2(4). The standby took over fine and no impact was seen to traffic, strangely, after 58 minutes the primary came back and took over. Running show fail on both units gives the corr...

how we config a ASA into transparent mode.....and what does actually that mean....i am really new to ASA.....is it possible to do it via GUI??? thanks guys

Hello - I have a CAS appliance configured for both VPN Auth SSO, and Windows Auth SSO. So which one will it attempt to run first? I ask because sometimes when I login over our RA VPN, I notice that the VPN auth provider logged me in, and others, I no...

I am trying to get my ASA5505 to sucessfully transport t-home IPTV Multicast traffic to my SetTop box.The key to get this done seems to be enabling the "ip igmp helper-adress" which unfortunately is only found in IOS code.I am not sure if the multica...

Hi Experts,I am using FWSM. I have 2 interfaces configured named Internet (Security-Level 0) and Server(Security-Level 100).I also configured icmp permit any Servericmp permit any InternetBut I am able to ping the interface Internet from Internet zon...

Hi all, I have a problem with pix 515e version 8.0(3) with asdm 6.0(3), I can't access to following sites www.rsp-informatica and http://www.jspires.com I notice that both sites are store in the same server (70.87.32.131), this server is a webhosting...

What is the difference between content security control and advanced intrusion prevention? The ASA 5500 offers these 2 seperate SSM Modules but I cant tell the difference in there capbilities.

HII have a ASA5510, with a segment 192.168.1.0 in the interface inside but I need to configure other segment new and Both segments have to communicate, as I do ?

ASA Version 8.0(3)ASDM 6.11Cannot login to an ASA 5520 using asdm or SSH just hangs on the login screen. This has been working fine for the last few months. I can still connect to the ASA via telnet from the one permitted ip address. Do I need to ...

Hi , I have setup FWSM in my lab , and configured a security context named it "test" and configured 3 vlan interfaces on it. I have disabled the NAT between these interface traffic. below is the setup. inside - 10.1.3.1 / 255.255.255.0inside-2 - 10....