Network Security

Can the IPS Express Manager software be used on a server with SAN storage? As far as you know there are no issues with using a SAN on the server the software is installed on. Is this product setup to have a backup IPS Express Manager Server for a p...

plese help me. where to start, I am reading but, I need a ideas, My IPS is 4240 and my ASA 5540

I need to get 400 users on the Internet with a pair of ASA5520's for high availability. If I get two 250 user models will this work? I figure that when both boxes are working each should have approx 200 users. If one fails then I understand all us...

On an IPS is there a way to create a filter so that it will not trigger any signature based on a specific source IP?So for example no signature will fire for source ip 10.1.1.1

I've heard that with a ASA 5505 the Security Plus lincese is required to pass traffic from LAN to DMA, DMZ to LAN. Is this the same with the ASA 5510?I have the ASA5510-Bun-K9 version

Good Day,Let me preface this by saying that I do not have control over our router and getting any configuration changes would be problematic. (strange but true)We currently have four subnets w/public IPs connected to 4 of the router ports. We are con...

Pix 515E 6.3(5)I need to permit my users access to an external website that uses port 8090.Would this be correct?access-list permit tcp 192.168.1.0 255.255.255.0 any eq 8090Would I also need: Fixup protocol http 8090Thanks.

we are using 3rd party ipsec in transport mode from client to server, but when i put ASA 5520 with dynamic NAT , client is not establishing ipsec communication with server even if everything is allowed. How can the client connect by NAT with ASA 5520...

I have set up an IPS senor and was getting a lot of alerts generated for signatures 12673 (Recognised Content type) and 12676 (Request method not recognised) these are generated when SMS clinets communicate with the SMS server.Analyses showed the con...

I would like to form a vpn between cisco pix 515 and watchguard 1250e. For some of the reason, I would like to route port 80, 443 services via watchguard to access the internet.I have success to make a zero route to route all traffic via watchguard t...

Hi Forum,¿How do I configure the firewall to let traffic by dynamic MS-Rpc ports (>1024) between member server in DMZ in DC and intranet?¿The Service Policy Rules would provide for that purpose?Thanks for all.