Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I am having a weird problem I can not explain, and need your input to solve this mystery. I have a viptela vedge connected to a Juniper EX switch/router that is the gateway to Internet, this vEdge router has many inbound/outbound IPsec connection...
Hi, I am trying to use NSO to manage Juniper SRX IPsec configuration, I am running latest juniper-junos-nc-4.5 NED on NSO 5.3, when I am trying to sync-from a Juniper vSRX running 18.4R1, I am getting the following error: admin@ncs(config)# devices s...
Hi,I am new to NSO, so apologize for my ignorance. I recently downloaded NSO 5.3 and I was able to successfully develop a static NAT service with real device being a Juniper vSRX, I can call API to successfully create a valid static NAT entry on vSRX...
Hi,
I am looking for a platform that can do static NAT in hardware, Here are the requirements:
1) Up to 512 static one to one NAT entries, NAT translation implemented in hardware, i.e. wire speed NAT translations, we only need static NAT transla...
hi, guys,
I am tasked to build an edge service pop for our business, I am struggling to decide which platform to use, Cisco ASR 1K or Juniper data center SRX (SRX-5400 or lower model), here are essential requirements:
1. Full routing protocol suppor...
Thanks for your reply, why would any device punt a packet based on QoS marking? regardless, BFD packets are encapsulated inside IPsec right? there is no BFD session running between Viptela and Juniper EX switch.
