Network Security

Hi, May i know the use of Management Int in ASA FW and if we make a DHCP Server in Management V-lan and make mutiple scope according to configured V-lans on FW using other interfaces then how the FW will allocate the Dynamic IP to the V-lans client m...

what is the way to connect the router to an isp which doesnot have serial interfaces but has fast ethernet ports? is it possible?

hi My topology1)Internet-router(2ISP terminated in Single Router-two different Firewall-(ASA5510 and PIX 515e)-->inside interface connected in IPS4240--->From IPS to L33750 Switch.Is right place to put IPS4240 and tell me IPS in which mode(inline or ...

Hi to all, I just wan't to know if how can I secure my Mail server if my PIX515 has only 2 interfaces (inside & outside) & no DMZ port to configure? I am thinking to use static NAT & ACL but if there is another way to secure it, can you tell me how?T...

Sorry for duplicate mail.HiHow can I change the Cisco ASA Console baud setting. Is their a way like Cisco Routers. I do know how to do the same with the Cisco Routers.

Hi there, I have two sites connected via MPLS network. In each site, ASA is connected to the MPLS router. Each ASA also connected to an ISP via another router. I would like to configure a VPN tunnel between the two sites that will be only used if MPL...

HiHow can I change the Cisco ASA Console baud setting. Is their a way like Cisco Routers. I do know how to do the same with the Cisco Routers.

i have installed Clean access 4.1.3.1 in the appliance 3310.it is L2-OOB-VGW-Central deployment. After taking the control the port the vlan is changing from access to authentication. after that the user page redirections not working, when i have trie...

Hello all,Can anyone point me to a software product (preferably Cisco) that will analyze a PIX 6.3 firewall rule set and determine which ACLs are not in use and which object groups are not referenced by any ACLs? I know I can show access-list to see ...

I am trying to get Microsoft DCOM through a FWSM. We use FWSM inside our network to protect our server subnets. One of the server is using RMC that is based on Microsoft DCOM. My understanding is the DCOM uses port tcp/135 for the beginning of the co...

Hi Team,local lan has the gateway as firewall inside ip. there is a 3750 L3 switch in between lan and firewall. now if we give the default gateway as firewall ip we [192.168.4.x] are unable to ping to 192.168.6.x network. But if we give the gateway a...

I am setting up an 871 Router on my own for the very first time for a customer. I was able to get the initial set up of the static public IP address and DNS settings set properly and users are able to get out to the Internet. I am now in the process ...