Network Security

We are planning to upgrade from 8.0(3) to 8.0(4). Are the any bugs in the new release? pls give your inputs..

I have a PIX-515 running v6.35 with remote VPN users connecting by pptp to the outside interface, so I use the "vpdn group" commands. For my users to get an ip address, this line does it:vpdn group PPTP-VPDN-GROUP client configuration address local m...

I have hits on a BO2K-UDP signature. I looked up the ip address on Arin and it is from a company that we would probably do business with. Using nmap, I fingerprinted the remote server and it appears to be a standard MS Web/Mail server.How do I tell I...

How does this work?http://www.cisco.com/en/US/docs/security/asa/asa72/release/notes/asarn72.html#wp84471The examples that I have show very simplistic configurations using private IP addressing and if were to have a standby ISP, how can I route the pu...

I have been getting more than a few of the following message on the ASDM console. What could this be? "inbound UDP" does that mean coming from Outside, with a private IP? Both source and Destination IP do not exit in our network. TIA"2 Aug 19 2008 20...

Hey guys,Just checking my PIX logs and I keep getting this alert "Aug 21 2008 09:37:15: %PIX-2-106016: Deny IP spoof from (127.0.0.??) to 108.122.0.0 on interface dmz"The last octet of the 127 address changes and it's to the same destination. Just wo...

I'm using IP SLA Monitor with a default ICMP Jitter operation to an ASA interface, but the firewall does not respond.How can I enable a reply to a timestamp request message?Thanks.

Say I have a network object group object in my firewall, and I wish to add in not just an IP but a range of IP's. 12.12.12.1 to like 12.12.12.10? I hope I am doing this wrong by entering in 10 ips vs just a range of some sort. Chuck

I have two new ASA 5510s, with 7.2(2)10 configured for active/standby failover.due to ASA interface limitation/availability, I am using only one interface for both LAN-base and stateful failover:interface Ethernet0/3speed 100 duplex full!interface Et...

Hi,I am trying to set up IP SLA configuration tool between 2 sets of Cisco Routers. Set 1 is from Dublin to Cork (Dublin IOS c7300-a3jk91s-mz.122-31.SB3.bin to Cork Cisco c2800nm-entservicesk9-mz.124-7a.bin with ip sla monitor responder enableD). Thi...

We originally posted files (Antivirus, Patches, SPs) in the requirements section but when files got too big it was not feasible.So we developed a web server solely to serve the certification zip files for students to meet the requirements.After they ...

Hello TogetherWe run a proxy server in the DMZ of our ASA 5505. The ASA is connected to a cable modem. If we download something (microsoft downloads, etc.) the starts accurate with about 1,5 - 2,4 MB/sec then drops down to 300-400KB/sec. The same thi...

Hi ThereI have a Cisco ASA 5510 with two WAN connections. WAN Interface #1 is configured statically with a static route, and this interface also handles all inbound traffic. WAN Interface #2 is a Cable Internet service, which I want to route all Outb...